Views: 0 Author: Site Editor Publish Time: 2022-06-12 Origin: Site
Tungsten steel circular knife blade is a common blade, and its material tungsten steel is also a common alloy material. It is made of a hard compound of refractory metal and bonding metal through the powder metallurgy process. This article will introduce the grinding method of tungsten steel circular knife blade and the heat treatment technology of circular knife blade for readers, hoping to be helpful to you in production.
Grinding method of tungsten steel circular knife blade
The heat treatment technology of circular knife blade
The first is to select the materials used for grinding. Grinding cemented carbide with silicon carbide grinding wheel can grind a very sharp edge, while corundum grinding wheel is not suitable for grinding cemented carbide, which is more laborious. When grinding, the operator should stand on the left side facing the grinding wheel to keep the main cutting edge on one side of the drill bit horizontal and slightly higher than the horizontal plane passing through the center of the grinding wheel. If the main cutting edge does not remain horizontal or even lower than the horizontal plane of the center of the grinding wheel, there will be defects of the incorrect shape of the main cutting edge or high flank.
Secondly, the correct included angle between the drill axis and the grinding surface of the circumference of the grinding wheel shall be maintained. It should be noted that the right hand is in front and the left hand is in the back. The drill tail is slightly lower than the drill bit. The drill edge contacts the circumferential surface of the grinding wheel, and appropriate pressure should be applied and a small range of lateral movement should be made. The drill tail should not exceed the horizontal plane to prevent grinding out a negative back angle. It should be noted that the two flanks should be ground in turn frequently. After grinding one side, do not take up the drill bit to see, but directly turn to the other side for grinding. Because the position of the hand remains unchanged, the two main cutting edges of the drill bit are not easy to have one high and one low.
After grinding the main cutting edge, stand on the right side and keep the main cutting edge level. The grinding of the side edge should be as few as possible to prevent the hole diameter from becoming smaller. The side edge to be ground is parallel to the drill axis or slightly reduced towards the drill tail. From the rotation direction of the drill bit, the main cutting edge and side edge should be slightly higher than the back, so that there are edges and sharp edges, so as to cut smoothly without jamming. Avoid excessive grinding, otherwise, the drilling edge will wear fast and not be durable.
As we all know, the heat treatment of a circular knife blade is a very important link to determine the quality of a circular knife blade. In order to meet the strict requirements of international environmental protection standards, the circular economy concept of comprehensive utilization of wood and continuous supply of raw materials has promoted the rapid development of the wood processing industry. Therefore, the vacuum heat treatment and cryogenic technology of cutting tools came into being.
Tool vacuum heat treatment technology has a series of outstanding advantages. One is that vacuum heat treatment has the function of anti-oxidation; Second, vacuum heat treatment has the function of vacuum degassing and degreasing, and there is no risk of hydrogen embrittlement; Third, the quenching deformation of vacuum heat treatment is small, which can reduce the possibility of fracture during the use of the blade; Fourth, the vacuum heat treatment process has good stability and repeatability; Fifth, vacuum heat treatment consumes less power, the power consumption is 80% of that of conventional heat treatment, and the production cost is low; Finally, vacuum heat treatment has the advantages of safe operation, high degree of automation, good working environment, pollution-free and pollution-free, which meets the requirements of cleaner production and sustainable development of national industrial enterprises.